Spot Flex

Flexible Fit. Targeted Coverage.

Shaped primarily for the knee, the flexible wrap also fits around the elbow or shoulder, keeping the illuminated section close to the selected area.

Over an Hour of Cord-Free Use

A rechargeable 5,000 mAh controller powers sessions without a wall outlet, with more than 60 minutes of runtime per full charge.

Red + Near-Infrared in Every LED

All 72 tri-chip LEDs combine one 660 nm red-light chip with two 850 nm near-infrared chips.

Recovery Where You Need It

Designed primarily for the knee.

Spot Flex combines red and near-infrared light with adjustable warmth in a flexible, wearable wrap. It also fits around the elbow or shoulder, with a rechargeable controller that keeps sessions free from a wall outlet.

Use Spot Flex for your targeted areas before training, afterward, or on recovery days.

Your Session, Your Settings.

Three Light Modes

Use red and near-infrared light together, or select either wavelength on its own.

Three Warmth Levels

Choose 100°F, 108°F, or 115°F (38°C, 42°C, or 46°C). Start with the lowest level, which is also the default setting.

Three Session Times

Select a 10-, 20-, or 30-minute session. The device shuts off automatically when the session ends.

Continuous or Pulsed Light

Use continuous output, shown as Pulse OFF, or select 10 Hz or 40 Hz.

FAQ

Which light mode should I choose?

Select RED + NIR to use both wavelengths together. Spot Flex also offers red-only and near-infrared-only modes if you prefer to use either wavelength separately.

Which warmth level should I choose?

Start with the lowest setting and increase only if it remains comfortable. Stop use if you experience excessive heat or discomfort.

Do I need to use pulse mode?

No. Choose Pulse OFF for continuous light output. If you prefer pulsed output, Spot Flex offers 10 Hz and 40 Hz - 10 or 40 pulses per second.

How long should a session be?

If you are new to red light devices, begin with the default 10-minute session. Do not exceed 30 minutes per session, and allow at least six hours between sessions on the same area.

Why does the wrap look unlit in NIR-only mode?

850 nm near-infrared light is outside the visible range of the human eye. In NIR-only mode, the wrap may therefore appear unlit even while operating.

Can I use Spot Flex while charging?

We do not recommend using Spot Flex while charging. A full charge takes approximately two hours and provides more than one hour of use, depending on settings. Disconnect the charging cable before starting a session.

How do I clean Spot Flex?

Turn it off, disconnect the controller, and allow all components to cool. Wipe with a soft, slightly damp cloth and let everything air-dry completely before use. Do not soak, machine wash, or tumble dry.