Spot Wrap
Front and Back Coverage. Together or Separately.
Two illuminated sections cover the abdomen and lower back. Select either area individually, or use both together without repositioning the wrap.
Over an Hour of Cord-Free Use
A rechargeable 5,000 mAh controller powers more than 60 minutes of use per full charge—without staying connected to a wall outlet.
Red + Near-Infrared in Every LED
Each of the 88 tri-chip LEDs combines one 660 nm red-light chip with two 850 nm near-infrared chips. Both wavelengths operate together in each active zone.
Recovery Where You Need It
Spot Wrap combines red and near-infrared light with adjustable warmth in a flexible belt for the abdomen and lower back. Use the front and rear sections separately or together, with a rechargeable controller for cord-free sessions around your training schedule.
Your Session, Your Settings.
Two Zones. Three Therapy Modes.
Abdomen: Activate the front section.
Lower Back: Activate the rear section.
Both: Use both sections together in one session.
Three Warmth Levels
Choose 100°F, 108°F, or 115°F (38°C, 42°C, or 46°C). Start with the lowest level, which is also the default setting.
Three Session Times
Select a 10-, 20-, or 30-minute session. The device shuts off automatically when the session ends.
Continuous or Pulsed Light
Use continuous output, shown as Pulse OFF, or select 10 Hz or 40 Hz.
FAQ
Can I select red or near-infrared light independently?
No. Spot Wrap’s controller selects the active body zone. Each selected zone delivers 660 nm red and 850 nm near-infrared light together.
How should I position the wrap?
Place the front illuminated section against the abdomen and the rear section against the lower back, with the illuminated surfaces facing clean, dry skin. Fasten comfortably and adjust if you feel pressure or restricted breathing.
Which warmth level should I choose?
Start with the lowest setting and increase only if it remains comfortable. Stop use if you experience excessive heat or discomfort.
Do I need to use pulse mode?
No. Choose Pulse OFF for continuous light output. If you prefer pulsed output, Spot Wrap offers 10 Hz and 40 Hz - 10 or 40 pulses per second.
How long should a session be?
If you are new to red light devices, begin with the default 10-minute session. Do not exceed 30 minutes per session, and allow at least six hours between sessions on the same area.
Can I use Spot Wrap while charging?
We do not recommend using Spot Wrap while charging. A full charge takes approximately two hours and provides more than one hour of use, depending on settings. Disconnect the charging cable before starting a session.
How do I clean Spot Wrap?
Turn it off, disconnect the controller, and allow all components to cool. Wipe with a soft, slightly damp cloth and let everything air-dry completely before use. Do not soak, machine wash, or tumble dry.